Operating Regulations of Laser Marking Machine

Operating Regulations of Laser Marking Machine

Method/Step

1. 1 Start up The steps to start up the laser marking machine are as follows:

2. Check the power cord of the marking machine to make it connected correctly and reliably;

3. Insert the key switch, turn 90o clockwise to the "on" position, and turn on the main power supply. The power indicator light is on;

4. Confirm that the laser head mushroom button (emergency stop switch) is in the pressed state;

5. Turn on the power switch of the computer monitor and the host computer;

6. Rotate the red mushroom button in the direction of the arrow to make it pop up, and the laser head can be switched on. After about 1 minute, the laser head will start up;

7. Remove the lens cover; At this point, the laser marking machine is turned on and can accept the operator's order to perform the marking operation.

1 Marking operation

1. Double-click the marking program icon to enter the program;

 2. Select the marking file, double-click the date and time in the content to modify, and click OK to complete the modification;

3 Marking test and printing position

1. On the workbench or production line, place a test piece equal to the height of the marked workpiece (it is better to choose the marked workpiece as the test piece), and confirm that the test piece is indeed stable;

 2. Marking by operating the marking control software. In order to make the best marking effect, the following steps can be adjusted:

1. Adjust the focal length by adjusting the lifting device of the bald head;

 2. Adjust the power, marking speed and other parameters in the marking software;

 3. Enter the software, double-click to print the date, and drag the mouse up and down to adjust the printing position to an appropriate position.

 3. After completing the above steps, you can perform a print test.

 4. After the test is correct, remark on the workpiece.

3 Shut down

After the production task is completed, the operation steps for turning off the laser marking machine are as follows:

1. Press the red mushroom button (emergency stop switch) to cut off the power of the laser head;

2. After confirming that the industrial computer is not running any software, exit and shut down normally;

 3. Turn the key switch 90o counterclockwise to the "off" position, turn off the main power of the marking machine, and the power indicator will go out;

4. Remove the key and have someone to keep it for the next use;

 5. Put on the lens cap.