FSCUT4000 laser cutting system high-speed, high-precision fully closed-loop laser control system

The FSCUT4000 laser cutting system is a high-speed, high-precision full-closed-loop laser control system independently developed and completed earlier in China. Supports advanced functions such as automatic adjustment, cross-coupling control, and smart perforation.

Specification

Adaptation software

CypCut laser cutting software

control card

BMC1214

Interface Type

32-bit PCI bus, 132MB/s

Terminal board

BCL3724

Power requirements

24V DC/2A

Motor control signal

X/Y1/Y2/W axis analog output, -10~+10V

X/Y1/Y2/W axis with encoder input interface, the highest sampling frequency is 10MHz

Dedicated input

4-channel origin: low-level effective, support normally open normally closed

8-channel limit: low-level effective, support normally open and normally closed

Dedicated output

4-way DA: 0~10V, 50mA

1 PWM: 5V/24V optional, accuracy 50KHz (0.1%)

Universal input

12 channels: low-level effective, support normally open, normally closed

IN10/11/12 support jumper change to high level effective

Universal output port

Relay output 6 channels: load capacity: 250V AC/5A, 30V DC/5A

Thyristor output 14 channels: load capacity: 24VDC/500mA

working environment

Temperature: 0~55℃

Humidity: 5%~95% (no condensation)

Performance characteristics

Craft

Any combination of segmented or progressive, fixed height zoom perforation and other intelligent perforation methods

Support pre-perforation, grouped pre-perforation, cooling point, stop light blowing, sharp corner ring cutting and other thick plate processes

Support speed detection, automatic adjustment, capacitor edge seeking, electric focus, workbench exchange, multi-task processing, automatic layout, flying cutting, leapfrogging, QR code, cutting line, maintenance and other advanced function modules

Support simple scheduling, virtual multi-station, scanning code map and other automated applications

Support starting, closing, and fine cutting processes

control

Closed-loop control system, adopts Baichu fourth-generation motion control algorithm

Control accuracy 0.005mm, actual trajectory accuracy 0.01mm, positioning accuracy 0.001mm, repeat positioning accuracy 0.002mm

Maximum cutting speed 80m/min. Maximum moving speed 200m/min

Maximum acceleration 2.5G

All master-slave dual-drive, cross-coupling control of each axis, forward-looking speed and acceleration.

Application industry

Suitable for high-precision laser processing equipment. It is widely used in precision processing occasions such as 3C industry, brittle and thin materials such as glass ceramics, polymer films, and eyewear accessories.

62 core wire

C62-2/5/10

quantity: 1