How to install the handheld laser welding machine? what should pay attention to?
Publish Time: 2022-09-28 Origin: dapeng
How to install the handheld laser welding machine? what should pay attention to?
What are the leading features of the handheld laser welding machine?
The handheld laser welding machine replaces the traditional mode of operation and has significantly improved the flexibility and safety level of the handheld welding process. Therefore, it is more convenient and efficient when welding in different applications, and the operation will be more and more convenient.
2. Handheld laser welding machine welding distance is longer, to overcome the limitations of the traditional table space. This has a significant impact on the quality of the welding process. After the introduction of the handheld laser welding machine equipment, this has a large improvement in the welding process and quality, which can be seen in the design standards continue to improve, to achieve customer satisfaction standards.
3. In the face of the workpiece size is not uniform can not automatically weld the case, handheld laser welding machine can also be used for welding. Therefore, after grasping the technical requirements and details in this area, we will know that the design standard in every aspect will be more reliable and achieve the welding quality standard to the satisfaction of customers, which is also more prominent in the performance quality, so that customers can choose to be more and more at ease.
It can be seen that, in contrast to traditional welding equipment, indeed handheld laser welding machine in the development and design of a unique, in all aspects of the performance level has improved.
How to install the new machine of laser handheld welding machine A: The method is as follows.
1. Before inserting the welding machine into the power supply and starting to work, wipe clean the contact points of the two upper and lower electrodes to avoid leakage and short circuit. 
2、Switch on the order: control circuit steering - welding current - adjust the level - water source - gas source - and finally only then turn on the power supply. 
3、After turning on the power supply, also check again whether the electrical circuit is aged and broken, whether the operating system is normal and whether the housing is leaking. If there are any problems turn off the power immediately for replacement.
4, while welding, pay attention to keep the surrounding environment dry, can not drain and according to the drainage temperature in the temperature below 40 ° to adjust.
5、When the welding process is found, the ignition tube can not produce an arc, it is strictly forbidden to go to increase the fuse and close the ignition circuit.
6, after the end of welding, to immediately cut off the power supply, pack each line, to avoid the danger of short circuit caused by accidental closure.